s10 steering wheel quick release

bradyhill1

Member
Joined
Feb 28, 2010
Location
society hill, sc
I recently put a roll cage and racing seat in my truck, now with my size its tough to get in and out of it. Been researching online for a removable steering wheel setup. Thinking I need to go with a weld on splined release hub. I think it would have less play and be safer than the ball setup. I need some input on this if anyone has experience with it.
 
yep ive done quite a few weld on quick releases. s10's are no big deal to do. buy a weld on that will fit over the existing splines. slide it on and use the factory nut to pull it tight. where they machine the factory spline into the shaft there is a small taper that will center it up nicely. i prefer a hex shaped release with a push pin. the splined type seize up to easy.
 
Chris, to ease his mind some isn't this exactly what you have on YOUR S10? ;)
 
Back
Top