Tacoma747
Well-Known Member
- Joined
- Mar 20, 2005
- Location
- Winston-Salem
Ordered a housing from RuffStuff, Dan thought he knew a measurement for the length of the rear tubes but that seems to not be the case. I already cut the spindles off my housing (and scrapped the housing), I could get them to make the tubes long, but I'd rather have it exact so I don't have to worry about cutting the tubes shorter (and them not being cut straight).
Basically, I need measurements from the center of a bolthole on each side of the 3rd to the 'center' of the weld where the spindle welds into the housing.
I am sure this does not have to be exact, within 1/4" should be fine I'd say as the splines should make up for any variance.
Thank you in advance...
Basically, I need measurements from the center of a bolthole on each side of the 3rd to the 'center' of the weld where the spindle welds into the housing.
I am sure this does not have to be exact, within 1/4" should be fine I'd say as the splines should make up for any variance.
Thank you in advance...
