Toyota alternator mounting bolts

NCJeeplover

Well-Known Member
Joined
Jul 25, 2009
Location
Claremont, NC
Does anyone know what size and length the alternator pivot bolt is on a 22re? It's the long one with a nut on the bottom.

I've seemed to misplaced mine and would love to get the alternator on this weekend. Thanks!
 
They're going to be M10 bolts (14mm head).
As said above, if you have the alternator off just measure the length of the tabs it passes through on the unit and add another inch or two. To some extent it doesn't have to be perfect b/c you're going to just run the nut down on it if it's too long. Hell a 3/8" bolt would probably work, just be sure to use fine thread so you can get the nut tight.
 
I was bored so I went out to the garage and measured.
The lower bracket rear section is a little thick.
Looks about 11.5cm long. Call it 12cm.

Keep in mind if you buy an M10 at a hardware store it will probably be E-spec at 1.5 thread pitch, not the J-spec 1.25 that matches the truck so get a matching nut too.
 
Ha, I just realized his post was Friday and you were going to do it over the weekend. So I'm late to the party o_O
 
Back
Top