Ok so I have a bit of an issue with the Turbo 350 I stuffed into my buggy. After getting the trans in, full of fluid, shifter hooked up, and so on, i realized that i was only getting Park, Neutral and reverse. The other gears were there but couldnt be reached with my cable shifter. After unhooking the shift cable i found that there was about and inch of play in each direction when moving the shift mechanism.
So i dropped the pan and noticed that the backing nut for the shift mechanism was loose. I was going to tighten this down and button it back up but i decided to take it all apart and found that the square hole on the internal shift bracket is now a bit rounded.
What Happened? Where do i buy a new bracket? or How do i fix the current bracket? and how do i prevent this from happening again?
http://www.nc4x4.com/forums/attachment.php?attachmentid=45459&stc=1&d=1326132798
