well, i blew a fuse yesterday when the trailer i hooked to had a bad wire, so i replaced the fuse and went on. about an hour later i noticed i didnt have any brake lights. i stopped, checked everything and rode on home as i was in a hurry. when i got home i replaced the fuse and it blew it immediately. i checked all the wiring again and checked all the fuses (i.e., pulled them all out.) redid a few wires on the trailer and replaced the fuse again and it started working again. figured everything was good. got in the truck to go to walmart and the abs and brake light came on, but the lights still worked. also, the speedo quit working. this time it set a u0121 and a p0513. then this mornin the check engine light came on and now its got a p0500 and the cruise dont work, the speedo still dont work and im gettin pissed off. i took all the battery cables for about 3 mins over lunch and it did nothing. so now im home for the night and ive got the negatives off while i sleep. any help you guys!?!?!?!?!?!?!?!?!?!
u0121 and p0500 on a 06 cummins, any help???
- Thread starter gmc2006
- Start date
- Joined
- Mar 20, 2005
- Location
- Hendersonville, NC
"Fuse 30 is where the F202 wiring goes into the TIPM. The cover on the TIPM lists fuse 30 as a spare. If there is no fuse in cavity 30, installing a 15 amp fuse in cavity 30 should fix the concern."
Dont ask where I pasted this from, this is supposed to be privy info. Also, the p0500 is a brake lamp switch dtc. Make sure, with a test light, that the fuses are good.
Let me know if ya need any more help.
Dont ask where I pasted this from, this is supposed to be privy info. Also, the p0500 is a brake lamp switch dtc. Make sure, with a test light, that the fuses are good.
Let me know if ya need any more help.