Weigh your rig on Digital Scales

Gotcha..

Hey, what's with the whole tractor thing on the PBB?
 
online calc - ya the math is all the same, that race car has provisions to factor in Stager (different tire sizes left/right) but thats basically the math formula in my spreadsheet. That one uses circumference as most racers use that as a comon way to diferentiat all thier tires.

greg - where in durham ? I work up off N. Duke St. we could maybe do somthing after work...

tractor - got me ? guy called me an idiot and i should stick to driving my tractor ? Must be a NC thing :) Funny part is I have driven farm tractors.
 
Mike I could bring my truck to work one day in durham to do this after work if you find a place to do it
 
where do you work off n. duke st. in durham?
we could use my shop on hillsborough rd. if that would work for you. it would give us the ability to lift the vehicles any way you would need to. friday would be awesome for me, as i travel alot thru the week, just let me know and i will try and make myself and the shop available for you and anybody else looking to get this done.

OR

we could do it at my house, about 15 mins up roxboro rd. whatever works best for you.

both spots have great level floors. i have measured before to adjust headlights for the state inspection requirements.
 
yager said:
tractor - got me ? guy called me an idiot and i should stick to driving my tractor ? Must be a NC thing :) Funny part is I have driven farm tractors.
Click to expand...
the other funny part is that guy was from Blacksburg ,VA....chances are he's been on a tractor or two.
 
greg slade said:
where do you work off n. duke st. in durham?
we could use my shop on hillsborough rd. if that would work for you. it would give us the ability to lift the vehicles any way you would need to. friday would be awesome for me, as i travel alot thru the week, just let me know and i will try and make myself and the shop available for you and anybody else looking to get this done.

OR

we could do it at my house, about 15 mins up roxboro rd. whatever works best for you.

both spots have great level floors. i have measured before to adjust headlights for the state inspection requirements.
Click to expand...

i work in RTP Friday I will headed to URE but That would work another day
 
greg - Im w/ ibm at the qualex building, glass bld. across from blockbuster.. If you want to do the COG stuff on the lift at the shop, that would be great to get a more accurate reading(s) or if you want just the corners, your house would be just as fine..

Friday 'should' be ok.. but i just sold the truck and will be needing to do the paper work later this week... Else we could all plan for next friday.

Carl - If you just wanted the corner weights I could probably do it at my work parking lot off in the back, the lot gets pretty empty after 6:00.. Hopefully no one will get uptight about it...

Else If you can find a spot near you and line up a few people I might be able to travel down that way..

Ive got em till the end of the month...
 
greg slade said:
we could use my shop on hillsborough rd. if that would work for you. it would give us the ability to lift the vehicles any way you would need to. friday would be awesome for me, as i travel alot thru the week, just let me know and i will try and make myself and the shop available for you and anybody else looking to get this done.
Click to expand...

Oooohhh, that would be perfect... if we can wait just a little bit - my replacement third is coming in this week, and I should be able to weld it up and install it this coming weekend...
 
Back
Top