My biggest issue with the newer dynasty welders, is you have to access hidden menus to get to all the options.
Miller discloses this as to make the front panel more intuitive for low end users and not to clutter the front panel. But how would a low end user even know that the hidden menus and settings exist, or how to get to them, with the hopes of moving forward.
As well, we had 7 dynasty’s, and there was very little consistency between them in terms of how the output is delivered. 3 of the 7 were close to each other, but the other 4 were all over the place.
The longevity of our machines was a joke. They were worked on frequently, with the first ones needing main circuit board, and high frequency boards replaced within the first year.
If you were only purchasing one machine, how would you know if you are getting a good one or a garbage one?
Due to differences from machine to machine, and the amount of repair these needed, all were replaced with Lincoln’s aspect system within 5 years of original purchase.
With 3 out of 7 machines being just ok, it’s hard to recommend that product line given the up front cost compared to other options.
Given those statistics if someone were to purchase new blue equipment, be sure to do so from your local welding dealer rather than online, so that you can have a face to face rep to deal with if any problems arise.
I started tig welding with old Lincoln square wave 275, and mp350’s. Since then, I’ve welded with Lincoln, Miller, esab, harbor freight, longevity, alpha, everlast, and otc.
For me personally, my everlast 255ext has been wonderful and no complaints, other than the fan running non stop. I agree that’s my only complaint.
It fit my budget, and I could replace it several times over before I approach the comparable miller or Lincoln machine cost.
I completely agree that I cannot tell much differences any, in quality/output of it vs others.
I keep referring to that model, 255ext bc it has the option for the advanced wave options and settings including triangular wave form.
As far as generic multiprocess mig/stick/ dc tig, the HF Vulcan is a freaking beast for the price.
I’ve welding with one of those a ton, and co pared it directly against my Lincoln mp210, and there is literally no difference other than price.
I still think esab has the best programming for mig welders that monitor arc voltage to keep output correct and consistent regardless of stickout, gun angle, and position.
