Where to source hummer wheel parts?

[off_road2]

Got some 24-bolt wheels and needing some, studs, nuts and o-rings. Is there any crossover part number for the studs? I know the nuts are just 1/2-20 flange nuts.

 

[ol'Jeeps]

I have gotten studs and orings from Trailworthy Fab

 

[snappy]

Orings get from mcmasterr-carr, they are pennies on the dollar to what everyone charges, but you do have to measure. There may be a thread in pirate that gives the part number

 

[paradisePWoffrd]

Here is a link to a discussion about studs:
http://www.pirate4x4.com/forum/hummer/936299-crossover-h1-stud.html
https://www.real4wd.com/zedsuite/catalog/partdetail.aspx?partno=12342758

Here is the reference that snappy was calling out from mcmaster:
http://www.nc4x4.com/forum/threads/h1-o-ring-question.73463/#post-627788

I have also seen people drill out/ream the holes and use 9/16" bolt/washer/locknut.

 

[Mac5005]

I used 9/16 fine thread bolts from McMaster. Way cheaper than studs.

Bolted the wheels together and welded the head of the bolt to the back of the wheel.

 

[cgm147]

http://www.sax-express.com/

Is where I bought studs, orings, and valve stems.

 

[paradisePWoffrd]

http://www.sax-express.com/

Is where I bought studs, orings, and valve stems.

I checked there and their studs are discontinued.

I typically drill the valve stem home to 5/8" and use of the shelf stems.

 

[cgm147]

Yea I just saw that... it's been a few yrs since I bought from them

 

[Lurch830]

I have gotten studs and orings from Trailworthy Fab

x2