1/2 round molding

[RatLabGuy]

You can get 1/4 round w/ a 3.4" radius. 2 of them is 1.5". Does it matter is the bottom edge doesn't really line up?
But I'm trying to figure out why you even need the bottom half of the semicircle, other than asthetics. It's just to give an edge to lean against that doesn't hurt and/or makes it easy to wipe crap off of right?

 

[CasterTroy]

But I'm trying to figure out why you even need the bottom half of the semicircle, other than asthetics.

If you had ever seen one of my motorcycles, guns, my Jeep, or really, my home you'd understand


It's really an illness

People who have bought my toys (RARE I ever sell anything) seem to really appreciate the attention I give the little things. This being no exception. It would bother me to no end to leave it cut like this. I wish I weren't like this....but it is what it is

 

[rockcity]

Use a router and put yourself your own radius on the edge to match.

 

[CasterTroy]

Use a router and put yourself your own radius on the edge to match.

This is potentially the route (pardon the pun) I will take. Just need to borrow one with a bit that will work

 

[Chris_Keziah]

You can get 1/4 round w/ a 3.4" radius. 2 of them is 1.5". Does it matter is the bottom edge doesn't really line up?
But I'm trying to figure out why you even need the bottom half of the semicircle, other than asthetics. It's just to give an edge to lean against that doesn't hurt and/or makes it easy to wipe crap off of right?

You could do that but add a 1/2x3/4 filler between them. Would probably look better than a full radius edge if it is blended well.

Sent from my SAMSUNG-SM-G890A using Tapatalk