Roid Rage Roger Buggy Build

[Landcruzn]

Hopefully my links will be put in this week and the motor and stuff mounted

 

[quickracer]

very cool looking..nice work

 

[upnover]

Which Atlas did you go with? Larry gonna do the exhaust?
350 or 400 tranny?

Done yet?

 

[Landcruzn]

I done the three speed atlas 2.0 2.76 5.44 I am running a powerglide and yeah Larry is going to do the exhaust we have been trying to figure out what I am going to run

 

[Landcruzn]

I am thinking of running race magnaflows and true duals there isn't enough room to put a x pipe in and it benefit

 

[GONOVRIT]

I am thinking of running race magnaflows and true duals

Can't go wrong there, build is lookin good man

 

[Landcruzn]

Thanks man

 

[Landcruzn]

thinking after breaking into the axle I may need to upgrade

 

[TheGriz]

Where's the beef? Those are some big ass joints.

 

[pcole0920]

ive seen some 2.5ton shafts break before but they was in 1000hp trucks and 55" plus tractor tires but then again i dont play in rocks lol

 

[Landcruzn]

ive seen some 2.5ton shafts break before but they was in 1000hp trucks and 55" plus tractor tires but then again i dont play in rocks lol

I have seen toyota motors break rockwells so that is not saying anything. I called them to get some info on the axles and found that I can only run the stock 5 ton axle in the 2.5 ton housing with cutting and changing the knuckles. Then to run the big boys you have to run the 5 ton with mods it is just to much trouble so I will probably stick with the u-joint axles until I decide whether to go with RCV's or Oversuns

 

[Landcruzn]

couple new pics

 

[paradisePWoffrd]

Did Scott tell you about RCV?

are you planning to run the shafts off the knuckle like that? I'm guessing you're planning to be wide?

 

[Landcruzn]

Well I know about the rcvs I don't know if we are going to leave them there so it may.be brought in right beside the knuckle

 

[backntac]

Lookin good brother!!!!!!!

 

[Oliver's]

Looking good Jody!

I can hook you up w/ RCV's if you go that route!

 

[y2kcrawler]

Man thats lookin good that rig is gonna be stout!!

 

[Landcruzn]

Yeah I may run rcvs I am going to stick with u-joint for now then decide I will let u know Dave. I am trying to figure out what wheels I am going to run now

 

[Landcruzn]

Found some u-joint replacements for the ball and claw axle that I found when I opened the axle up I think these will due

 

[Chris_Keziah]

Yeah I'm pretty sure those million spline shafts will do

 

[Landcruzn]

I hope so I had to give a fortune for them hahahaha so I am not going to complain to much I guess off to the machine shop tomorrow

 

[Landcruzn]

Got a couple new goodies from a friend in Las Vegas just waiting on the orbitol and steering shaft

 

[kilbys85]

nice

 

[Landcruzn]

Yeah I would like to get the front on the mount this week and the rest of the links mounted up and welded in. The spindles should be done sometime this week and I can get the ouveruns put in the rear and it finished up

 

[GONOVRIT]

updates???