Project dirt dobber

So I found out why my pass rear wasn't pulling. I pulled my diff and found this

ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1894_zps76016e78.jpg

So I welded it up right and threw it back in, should be good to go from here.
ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1899_zpsbdac46e9.jpg

I worked on my full hydro and got a lot done, orbital was mounted and welded my link to the steering shaft, mounted my ram, worked out well for a big cylinder, I'm happy with it and he price of it, all I need now is the pump bracket and I should be good to go I should have the belt tomorrow as well,
ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1901_zps3be0b421.jpg

ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1900_zpsbe3c9244.jpg


ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1905_zpsa753468a.jpg

ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1908_zpsf3450649.jpg
 
Yep just got off the slopes rode by crozet on the way wish they still haf open rides

Sent from my SCH-I535 using Tapatalk
 
Me and trey went 1 time it was great I broke all my hub studs 30 min after we got there but its pretty tecnical like one giant rock garden but over all pretty small

Sent from my SCH-I535 using Tapatalk
 
Saved some pics from online, from karatejosh or x-jeeper, looked cool

ai1052.photobucket.com_albums_s455_orv_design_fab_1507068_10155b85050526c882ccdc9db14907c550e8.jpg

ai1052.photobucket.com_albums_s455_orv_design_fab_1526417_1015f524d23b12393474cc77624ef5096b3c.jpg
 
Thanks bud! Sorry I haven't called you back. You have to go wheeling with us,
I wish I could say I cut it out with the plasma table...but I didn't
I broke something in my transfercases... We shall find out soon. The flats is coming up in two qeeks
 
So I fired up the heaters in the shop and pulled my cases out. The rear is trashes. My rear input is a 23 spline marlin so I'm excited about that. Swapped the input shaft out in my new case. I have to replace all my harware to bolt the crossmember back under the truck, but shouldn't be bad. turned out nice! All I have left to so I bolt up my tc pump fory full hydro, and check all my fluids. And go over the truck with a wrench and I'm set. Next Fri looks like I'm rolling out.

ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1981_zpsed2cf405.jpg

ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1983_zps5fecf803.jpg

ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1984_zps9782489b.jpg

ai1052.photobucket.com_albums_s455_orv_design_fab_IMAG1985_zps48086a5b.jpg
 
While josh had jack stands under the front end, I found a loose wheel bearing so I tightened that this evening after work. Should finish up wed. And load it and tighten all bolts thurs evening. And roll out Fri am :) its gonna be a good weekend.
 
Back
Top