Wide Open Design LJ buggy build

[Jody Treadway]

Is that driveshaft for mockup only? Just curious why it’s not beveled for the welds

It's been sleeved twice before so I'll retube it later.
The tube is 2" x 3/8" and machined out on one end. I didn't have any replacement tube so I'll farm it out.

 

[Kickdeez]

Had an afternoon to start on the front half of my exhaust. With the 4 link up front, it's pretty tight underneath.
Cut up my old front driveshaft and tacked it up so I can route the downpipe around it. Forgot it was 3/8" wall DOM!
View attachment 457785
After pie cutting the drivers downpipe, I was able to mock up both sides and back to the 2 into 1 collector.
View attachment 457786View attachment 457787View attachment 457788View attachment 457789
Gotta run by the muffler shop and get the downpipes swelled a hair and then I can finish weld it all.
After I get the exhaust done, I can set it at ride height and move on to interior items.

 

[Shreddinlettuce]

View attachment 457802

Like Reba circa 1993

 

[Jody Treadway]

Like Reba circa 1993

Finally, I am understood

 

[Shreddinlettuce]

 

[Monkeynono]

View attachment 457805

Ohhh that hair!!!!