Tacoma SAS in progress

heck yeah, man. i'm ready. just got a few more things to finish. picked up my front cv shaft from clayton today.
 
looks awesome, i met you in the concord autozone a few weeks back, wish i could get mine a little more in the air like yours
 
thanks man. yeah, i remember meeting you (tonka toy). i'm sure i'll see ya around.
 
got my new All-Pro rear springs in today.
ai123.photobucket.com_albums_o307_SSIROK99_all_pro.jpg


ai123.photobucket.com_albums_o307_SSIROK99_100_0525.jpg
 
here's some poser pics in the back yard...
ai123.photobucket.com_albums_o307_SSIROK99_027.jpg


ai123.photobucket.com_albums_o307_SSIROK99_028.jpg


ai123.photobucket.com_albums_o307_SSIROK99_029.jpg


ai123.photobucket.com_albums_o307_SSIROK99_030.jpg


still gotta put the new rears on, put the 48" rears up front, make my tranny x-member, and install my t-case flange, pinion flange and front d-shaft.
 
thanks man. i'm planning on taking it out when everybody goes at the end of april, but i may try to take it before then just in case there is anything that needs to be addressed.
 
I saw you at DPG saturday but just saw it sitting nice truck man!You going with the eagles crew to URE?If so Ill be there would love to wheel with ya!
 
Im a rogers buffs a fam friend we live all around his shop bc cycles is my dads so yeah ive been around bikes forever too..looks good
 
bigben--yeah, i saw you out at DPG too. badass truck! i like it. i'm gonna try my hardest to be out there at URE. should be all done by then. hopefully in the next week or two actually.

nckrawler--that's cool. buff is an awesome guy! so you're dad is Blake then?
 
got the All-Pros put on today after work......love em. they flex sooo much better than AALs and blocks. haha...
 
how do those axle work out with the ratio being slightly defferent??


COOL TRUCK!! you have the 3rz in there!?!?! COOOOOOL!!!:beer:
 
got the tranny x-member made today and put the front driveshaft in. it's 4wd again finally!

ai123.photobucket.com_albums_o307_SSIROK99_driveshaft.jpg


ai123.photobucket.com_albums_o307_SSIROK99_driveshaft2.jpg
 
man that pinion angle looks steep!!
 
it looks like it in the pic, but it's really not that bad.
 
FUNrunner--thanks. yeah, it's the 3rz motor. and as far as the ratios being slightly different, they're close enough to where it won't bind up anything. i played around with it in the backyard yesterday.
 
haven't measured to the roof, but to the bottom of the frame is 27.5".
 
I hope everyone got out OK and no one injured.
 
thanks man. i'm going to pick it up today and start stripping it to start on another one and part out some stuff i can't use for an earlier yota. i think this time i'm gonna do an 86-95 SAS.
 
Back
Top